The joint design is standard in many countries. The seal is easy and clean to handle as the lubricant is enclosed in the sliding mantle. This allows installation with very little force as there is no friction between the rubber and concrete.
The joint is designed so that the pre-lubricated mantle rolls onto the top of the spigot shoulder and into the small gap between spigot and socket during installation. This prevents concrete to concrete contact and gives efficient distribution of transverse shear loads across the joint. The design optimises joint peformance and provides an exceptionally high level of operational reliability.
Trelleborg 146 Pre-Lube Seal meets all relevant current European standards. Joint performance is dependet on dimensional accuracy and surface finish of socket and spigot.
Synthetic SBR or EPDM rubber
Hardness 40±5 IRHD
Approved in accordance with EN 681-1
Protected against ozone
Pre-lubricated seal for concrete and manhole systems
|A, MM||B, MM||C, MM||D, MM||JOINT GAP|
|Please contact Trelleborg Pipe Seals for technical advice and joint design recommendations to meet your performance requirements.|
All data in millimeter.
On each seal, profile thickness, outer diameter, recommended pipe measurement and production period are given. The corresponding data are also on the packaging.
Subject to change for technical reasons
Stretch the seal onto the spigot and position against the shoulder.
Equalize the stress in the seal by lifting and releasing at a few points. The seal must sit evenly against the spigot shoulder all around the manhole. Lubrication of the socket or spigot is not required.
Technical Approvals, Patents, Quality Standards
How can we be of assistance? Please fill in the form to request more information