Forsheda 101 is a compression seal which is rolled into place during joint assembly.
This joint design is standard in many countries.
The Forsheda 101 seal meets all relevant current European standards. Joint performance is dependent on dimensional accuracy and surface finish of socket and spigot.
Synthetic SBR or EPDM rubber
Hardness 40±5 IRHD
Approved in accordance with EN 681-1
Protected against ozone
Oil resistant grades are available on request
Seal for low pressure concrete pipe and manhole systems
100 % leak-free
|A, MM||B, MM|
|Please contact Trelleborg Pipe Seals for technical advice and joint design recommendations to meet your performance requirements.|
Ensure both spigot and socket are clean. Stretch the seal onto the spigot with the point of the G-ring facing outward.
Equalize the stress in the seal by lifting and realising at a few point. The sealmust sit evenly all around the pipe.
Centre the pipes and assemble by using suitable equipment. The G-ring will roll over and seat itself in the socket.
Technical Approvals, Patents, Quality Standards
How can we be of assistance? Please fill in the form to request for more information